Cheat Engine

Erez Zrihen

This will be great, if there will be an option to show only the instructions that their count is equals to, or greater than, or smaller than an specific unsigned integer. Using this option will make the search for an specific instruction much more easier.

For example, I want to search for an instruction that I want that it is executed only once, but there are much more instructions that write to the same address, but more than once on an event, so I want the list to show only the instructions that their count is 1. The rest I want to disappear from the list (that their count is greater than 1).

In memory view, there is "Find assembly code" option. The same option should be also in "Find what accesses & writes to this address" to find the wanted instruction even more easier!

++METHOS · Posted: Wed Mar 16, 2016 1:37 pm Post subject:

Try ultimap.

Erez Zrihen · Posted: Thu Mar 17, 2016 4:44 am Post subject: Reply to METHOS++

What is ultimap exactly?
I have never used this feature before!
How do I use this exactly?
Thanks for your reply!