Cheat Engine

tnok85 · Newbie cheater Reputation: 0 Joined: 12 Feb 2011 Posts: 14

Heya,

Having some trouble working out a way to make a trainer for Windows 7 x64. (Pretty much every trainer maker I have found does not run on x64)

Basically, I have narrowed down three pointers for XYZ teleporting in a game.(Took a while... then I figured out the Y and Z were just offset by 4 and 8, made it easier.

The first is:
.exe+008843D4 Offset 7C
Offset 134
Offset 4
Offset 18
Offset 30

The second is the same except the last offset is 2C, the third is the same except the last offset is 28.

I can manually change the values to teleport - but that's VERY slow. I can't use Cheat Engine 5.6 with the game, so I can't make the trainer there. The LUA section of 6.0 looks like it might do the trick but I'm not quite sure where to go with that...

I want to press a button (or a hotkey) and it will change all the X, Y, and Z values at the same time to one preset in a set of pre-entered locations.

Some direction would help - would LUA do what I'm looking to do if I learned it?

Dark Byte · Posted: Sat Feb 12, 2011 6:19 am Post subject:

The lua functions in ce are ce specific
You will have to write your trainer inside Cheat Engine and then launch it using Cheat Engine and then give your trainer table (a .ct with a gui) to people to use

but yes, it should be possible to do that with the scripting engine of ce. (You don't even need lua for that, the hotkeys can even do that, but you might want to use lua for gui stuff)