Cheat Engine

Tyrallis · How do I cheat? Reputation: 0 Joined: 06 Sep 2021 Posts: 3

Helloo,
I want to try and make my own cheat engine trainer and got myself godmode and infinite ammo, but i can't seem to find what i'm looking for. I used the methode of pausing my game when i shoot and do an increased scan and unfreeze and do an decrease scan, it got me only so far and i don't know what to do anymore.
Does anyone know how to find it and will be so kind and give instructions?
I can use several trainers but i want to find these Addresses by myself and with some help ofcourse Smile

LeFiXER · Posted: Mon Sep 06, 2021 12:43 pm Post subject:

Browse the memory region of the address where you found your ammo value. Set the display mode to float then shoot in game, look for values that change. There is a bit of guesswork required but I'm sure you'll be able to find it.

Tyrallis · How do I cheat? Reputation: 0 Joined: 06 Sep 2021 Posts: 3

I did that, found X and Y of my camera, NOP something and then i had no recoil but i couldnt move my camera, that was the only thing close to it that i found.
And i found a way to disable the crosshair spread by a bit. I tried everything, either game crashed or nothing changed

LeFiXER · Posted: Mon Sep 06, 2021 11:11 pm Post subject:

It may not always be directly near it but make sure that the instruction isn't accessed by other opcodes. If it is you'll have to scan for commonalities to filter them.

Tyrallis · How do I cheat? Reputation: 0 Joined: 06 Sep 2021 Posts: 3

Sorry that i'm not so experienced but may you give me an explanation for retards? How do i check if the instruction isn't accessed by other opcodes? nad how do i scan for commonalities to filter them? Embarassed

LeFiXER · Posted: Wed Sep 08, 2021 4:48 am Post subject:

Once you've found the address that holds the value > Right-click it to bring up the menu within Cheat Engine's main window and select > Disassemble memory region (Ctrl + D) > Right-click the highlighted line and select > Find out what instructions this address accesses. A new window will popup, now, in-game try to alter the value you want to manipulate so that the address appears in the new window. The value should match in that window and the main Cheat Engine window so that you know it's definitely the correct address, select it and assign it to group 1. If nothing else pops in then the address isn't a shared opcode. If it does, assign the rest (minimum of 3 is recommended) to group 2 then scan for commonalities.

If you have to scan for commonalities, there will be a constant value for the address you want to manipulate but some other value for everything else. You'll be able to compare based on what values are there and which offset holds that value.